Stealing A Locomotive AddressDigitrax systems do not allow more than one user to select and run the same locomotive address unless the loco is “stolen” (or shared) by the new user. When an address is receiving commands from more than one throttle, it may seem to be out of control.Stealing is a safety interlock that prevents operators from automatically taking control of locos that are already selected and being run on another throttle. Occasionally you may need to override this interlock to gain control of a loco. This override is called stealing and will result in having a single loco ...
How to Select and Run a DCC Locomotive Using a DT402 or DT400 Series Throttle 1. Activate the throttle's left throttle knob “L” by turning it a 1/4 turn in either direction or by clicking the throttle knob once. The left side address will begin flashing. If nothing is selected on this throttle it will flash “SEL”.2. Press the LOCO Key. The left side of the display will begin flashing. The illustration above shows the LCD display just after you press the LOCO Key to select an address on the L Throttle when nothing has been selected on that throttle before and ...
If you are NOT plugged into a LocoNet port1. Use the 4 rotary address selector knobs on your UT4 to dial up the 2 or 4 digit address of the locomotive you want to run. To enter a 2-digit addresses, set the first two selector knobs to 0 and enter the two digit address on the 2 address selector knobs on the right hand side of the throttle (for example 0025).2. Plug the UT4 into any LocoNet port and automatic selection occurs.3. A Green Status light confirms that selection has been done successfully - You’re off and running!4. A Red Status light means the loco is ...
1. Choose which THROTTLE knob (L or R) you want to use to run a locomotive. Make it the active throttle by turning the throttle knob a 1/4 turn in either direction or by pressing down on the knob.2. Press the SEL key. The active throttle display will begin flashing the Loco Icon, the last loco address selected on the throttle and the Lo mode indicator. Sel loco will be displayed in the Text Area of the LCD display.3. To select a 4 digit address, rotate the L THROTTLE knob to dial up the first two digits (1000s and 100s) of ...
These are the basic DT400 and DT402 series throttle operating instructions designed to get you “up and running” quickly and to minimize your “frustration level” as you learn to use the throttle. Turning Track Status On and Off To run your layout you must be sure track power and track status are both ON. Follow these steps with your DT400 or DT402 series throttle to do this. Press the "PWR" key on the bottom left side of the throttle. The words “+ON -OFF” will come on in the display. Press the “Y +” key quickly and you should see the ...
Selecting a locomotive address to run on your DT4001. Place the locomotive you want to run on the track. Turn the throttle knob you want to run a loco on slightly counter clock-wise letting the controller know you want to address that side. 2. Press the "LOCO" key 3. Select the address of the loco by entering it using the numeric key pad.,4. Press the "LOCO" key to complete address selection.