Q: How do you reverse the direction of the engine so you can run them on the same train with one in the backwards position?A: Before consisting the locos, make sure that both are traveling in the SAME PHYSICAL DIRECTION ON THE TRACK. The locomotives can be arranged in either orientation hood forward or backward as long as they are set to travel in the same physical direction when you set up the consist.(The direction indicators on the throttles may or may not match, the important thing is that the locomotives are set up to move in the same direction and are ...
Your locomotives look like the real thing, Digitrax LocoMotion™ System makes them run like the real thing, too! 128 speed step control. Smooth deceleration to stop before changing direction when locomotive is reversed. No sudden, non-prototypical stops! Torque compensation for the smoothest operation ever. Momentum with acceleration and deceleration settings. Set normal direction of travel for your loco. Switching speed feature for quick access to slower switching speeds. Simple 3 step speed tables are easy to set up. Advanced 28 step speed tables with 256 level resolution. Scaleable speed stabilization feature. ...
CV29 is called the configuration register. It controls the following decoder characteristics: 1. Whether the decoder uses 14 speed steps, 28/128 speed steps or loadable speed tables. This affects how smoothly the loco will move and how it responds to throttle controls.2. Whether the decoder automatically converts to analog mode when no DCC signal is present. This allows the decoder to operate on a DC layout even though it is DCC equipped.3. Defines the normal direction of travel for the locomotive. Normal Direction of Travel or NDOT can be changed when the motor connections of decoder have not been connected so that the locomotive runs ...
DT402 & DT400 Series Throttles Locomotive Directrion Control There are two ways to change the direction of the locomotive address from the DT402 and DT400 Series Throttles:Double click the Throttle Knob to reverse the direction of a locomotive running on that throttle:1. Double click the Throttle knob that is controlling the locomotive. Press down on the knob quickly two times (2 distinct key presses within 1/2 second).2. The locomotive selected on that throttle will change direction.3. Repeat the process to reverse again, etc.4. Double clicking the R Throttle knob will reverse only the locomotive running on that throttle. Double click ...
Q: I have three engines lashed together. The sound is coming through . However when I turn the knob there is no response. The engine in the window is blinking and there are two stationary dots above A: If you are using a DT300 series or DT400 series throttle, make sure that the Track Status Indicator dot in the upper right of the display just below the right throttle knob is on solid. If it is not on at all Track Power is OFF. If it is blinking, Track Status is in Idle and the throttle knobls will not move the locos. To ...