You are viewing all articles in Throttle Operation -> Dispatching An Address from a Throttle (including subcategories). To further filter by subcategory, select from below.
The DISP Key is used both for displaying programming information and dispatching loco addresses.
Dispatching is a special feature incorporated in the LocoNet "language" to meet the needs of operators that wish to enforce a strict discipline in how operators gain access to locomotives during an operating session.Dispatching also lets you run MUs with basic throttles (such as the Utility Throttle series) that can't set up their own MU's and run four digit addresses on basic throttles that only have two digit capability (such as UT1 and UT2). It also lets you have newcomers run trains on the layout without giving them access to the entire operation.When you dispatch a locomotive address or MU ...
Dispatching is the process of releasing a loco so that another user can take control of it. To release, or dispatch, a loco under current UT4 control:1. Unplug the UT4 from the LocoNet port.2. Press and hold the DISP (Dispatch) key.3. Plug the throttle back into a LocoNet port.
Dispatching is a special way of offering a locomotive address to a UT1 or UT2 to run. The address is set up and then dispatched to the system to be acquired by the next throttle that presses its ACQUIRE Key. This is not the same as releasing a locomotive address from the system. Releasing an address clears it from the locomotive slot to make room for another locomotive address to be run by the command station. 1. Set the address selector switches to address “99” then press the “ACQ” button. 2. The Status LED will light green showing that you ...
Dispatching is a special feature incorporated in the LocoNet language to meet the needs of operators that wish to enforce a strict discipline in how operators gain access to locomotives during an operating session. Dispatching also lets you run consists with basic throttles that can't set up their own consists and run four digit addresses on basic throttles that only have two digit capability. It lets you have newcomers run trains on the layout without giving them access to the entire operation. When you dispatch a locomotive address or consist to your LocoNet system, you make it available to be ...
When you are finished running a locomotive address, release if from your throttle so that it is available for other throttles to select and run. This also clears slot space in your command station to allow other addresses to be run in the system. Note: Simplex Radio & Infrared Throttles must be plugged in to LocoNet to release an addresses from your throttle. Duplex radio throttles can release an address from your throttle without being plugged in to LocoNet.To release an address from a throttle: 1. Use the throttle to set the locomotive's speed to zero. 2. While the loco's address and ...
Although the UT1 can only handle addresses between 00 and 99, it can be used to operate one four digit locomotive address. 1. On the UT1 dial up 992. On a DT100, DT300 or DT400 series throttle, dispatch the four digit address you want to run on the UT13. On the UT1 press the ACQ (acquire button) to run the four digit addressNote that dispatching is a special state and the first UT1 throttle to press the Acquire button after the dispatch from another throttle will acquire that address to run.