Product Support for: Sound Decoders -> 1 Amp HO/N SoundFX & Function Decoder (SFX0416)

Q. I tried to program an SFX0416 with my PR2 and the sounds did not "Take". I clicked the big green "Program" button and after the initial buzzing for about 15 seconds, nothing further happened and now the unit makes no sounds. I am using a Compaq XP-home 1.5GHz laptop with SoundLoader version 1.16. How can I fix this? A. The most likely issue is that you are using the earlier SoundLoader version 1.16, which was not configured for full support of 16M bit flash sound memories, such as those used in the recently released SFX0416. SoundLoader was updated in ...

Wired Mobile Decoder with SoundFX™+Accessory type functions for most HO scale Locomotives. The sound project loaded into this decoder may be operated independently of any other DCC motor or function decoder. If another non-Sound FX compatible DCC decoder is connected to the track leads, then CV readback of SFX0416 Sound CV's and PR3 SoundTest modes may not be possible. Note that it is always possible to Write CV values using Operations mode or a Service Mode programming track, even if CV Read is inoperative. If the connected function loads are insufficient for CV readback with a PR3 or an incompatible ...

Wired Mobile Decoder with SoundFX™+Accessory type functions for most HO scale Locomotives.

Wired Mobile Decoder with SoundFX™+Accessory type functions for most HO scale Locomotives. 1. Connect the Red and Black track wires from the 7 connector Track and Function leads to the locomotive track power connections. 2. Connect the function leads that are to be used from the 7 conductor Track and Function wire set. Note that to be able to readback Sound FX CV's a combination of function lead loads of at least 60mA at 12volts should be connected to these function leads. Insulate the unused function leads so they cannot short to the locomotive frame or track power. 3. Mount ...

Application Note: Steps needed for installing the DN143IP mobile decoder into the Con-Cor N-Scale Aerotrain "DCC Car". The image above shows the “DCC Car” for the N scale Con-Cor Aerotrain, which is the 1st car behind the loco. It shows the holes in the underbody, above which a speaker can be mounted for a sound decoder installation. The recommended Digitrax sound decoder would be our SFX0416, but to use this decoder the seats will need to be removed. There is a pocket that is 16mm wide, 36mm long and 3mm deep designed for a speaker above the underbelly and under ...

The image above shows the “M-10000 Coach Car B” for the N scale Con-Cor M-10000, which is the 1st car behind the loco. If you look closely, you can see the holes in the underbody, above which a speaker can be mounted for a sound decoder installation. The recommended Digitrax sound decoder would be the Digitrax SFX0416, but to use this decoder, one or more of the seat sections as shown below will need to be removed. There is a pocket that is designed for a speaker above the underbelly and under the center section of seats. The speaker that comes with ...