Momentary or Non-latching Function Operation (Playable Whistle)

UT4 Function Control Keys and How they WorkThere are 8 physical keys used to control functions F0-F12 on the UT4 throttle. F1 through F6 and F7-F12 share the same keys.  You will see F1-F6 in black print and F7-F12 in blue print to remind you that you will need to use the SHIFT key to access F7-F12. To use functions F7-F12 you must press and hold down the SHIFT key on the lower left row of the throttle as you press the F7 through F12 keys to activate any functions available on those functions. All the UT4 functions work like other Digitrax throttles. ...

There is a numeric keypad on the DT402/DT400 throttle.  The numeric keys on the keypad are primarily related to the throttle mode shown in the LCD’s mode indicator area, but can be used for numeric entry and function control in other modes. For example, when the command station is in the Function Mode Fn, the numeric keys are used for function control. When the command station is in the Locomotive Mode,Lo, the numeric keys are used to enter loco addresses. When the command station is in the Switch Mode is Sw, the numeric keys are used to enter switch addresses.In ...

The DCS50 Zephyr normally treats Function 3 as an on/off function unless you set it up as a non-latching function like Function 2. This means that F3 can be used either as a normal function operating as an "On / Off" switch, or to control a function that only requires a momentary activation like some couplers.To set up Function 3 as a non-latching function, set the DCS50’s Option Switch 6 to closed as follows:1. Press the PROG key. The last programming mode used by the DCS50 will be displayed.2. Press the SWITCH key. The display shows the last switch used ...

DCS50 Zephyr can control Functions F0 - F8. Most DCC mobile decoders have function outputs that you can use to control lamps, LEDs, sound, smoke generators and other on/off devices installed in your locomotives. Most locomotives made today come with a head light and sometimes with a rear light, too. With DCC, these are controlled by the decoder’s function outputs. You can also install additional DCC controlled lighting such as cab lights, Mars lights, ditch lights, rotating beacons and others on your locos. The addition of these functions can add to the fun and realism of your locomotives.You must have ...

The DT400 can control Functions 1 - 12.Note: DT400 can access F0-F12 when used with the DCS50 Zephyr or DCS100 Super Chief command station. DT400 can only access F0-F8 when used with a DB150 Super Empire Builder command station.To enter Fn (function) mode:1. Determine which throttle you want to control functions on and make it the active throttle by single clicking the throttle knob or by turning the throttle knob a couple of clicks.2. DT400’s numeric keypad is always active in function mode during normal loco operations. When the mode indicator on your DT400 shows Fn, simply press any number ...

DT400 Series Throttles - Make F2 Latching or Non-latching The F2 button on the DT400 is meant to control locomotive whistles and horns, so it is configured to be "momentary" or non-latching.  This means that the key will activate the horn or other function for as long as you hold the key down and stop when it is released. This was done to facilitate the use of a playable whistle in sound decoders. If you are not using F2 for this purpose on your layout, you can change the way the F2 key on the throttle works so that it latches on and ...