Configurable Strobes

CS (configurable strobes) are function outputs can be set up to be simple on/off functions or as single or double pulse strobes. The CS option was available in very early decoders where there were not enough resources to allow for full FX functions.

Configurable strobes are controlled with CV49 & CV50. CV49 controls the White Lead   CV50 controls the Yellow Lead The value programmed for each CV consists of 2 digits, the first digit controls the conditions under which the light will be active.1x=Reverse, if 1 is the first digit then the light will be on when the locomotive is in reverse2x=F0 Qualified, if 2 is the first digit then the function will be active when F0 is on and off when F0 is off4x=Direction insensitive, if 4 is the first digit then the function will be On in either directionThe second ...

Configurable strobes are set up using CV's 49, 50 and 61. Configurable strobe function leads can be programmed with a limited number of simulated lighting effects similar to FX effects but without as many options. Configurable strobes are offered in those few Digitrax decoders where there was not enough "code space" to provide full FX features.CV49 controls F0 Forward, the white function lead. CV50 controls F0 reverse, the yellow function lead.CV61 enables the configurable strobe operation.To set up configurable strobe lights:1. Program CV61 with the CV value "01" to enable configurable strobe operation.2. Program the CV value for CVs 49 ...

The DT400 can control Functions 1 - 12.Note: DT400 can access F0-F12 when used with the DCS50 Zephyr or DCS100 Super Chief command station. DT400 can only access F0-F8 when used with a DB150 Super Empire Builder command station.To enter Fn (function) mode:1. Determine which throttle you want to control functions on and make it the active throttle by single clicking the throttle knob or by turning the throttle knob a couple of clicks.2. DT400’s numeric keypad is always active in function mode during normal loco operations. When the mode indicator on your DT400 shows Fn, simply press any number ...