Stall Current

Stall Current is the max current draw in amps for a motor when it is stalled. This is important in determining which decoder to install in a locomotive. Why is Stall Current important? In the conversion of analog locomotives to DCC, how much current the locomotive draws is a major factor in decoder selection. Decoders are grouped by their ability to handle the electrical load that flows through them to the locomotive motor. The Ampere (Amp) is the unit of measure for electrical current used by the locomotive. The current draw of most HO can motors is between .5 and 1.5 ...

Q:  Can one decoder be wired to run two engines, such as an A-B unit that do not get separated? A:  Yes, as long as the current capacity of the decoder is not exceeded. We recommend that you check the stall current of both locomotives before installing a decoder that will handle both. Note that you can control two locomotives with decoders as a consist or MU lash-up so that you do not have to use a single decoder to control both locos.Issues we have seen with using a single decoder to run two locos together:1.  Make sure your wiring between ...

I have several old brass locos and they have Pittman motors. I have tried DH163 Decoders and blown two. I believe that they draw excess current that exceeds 1.5amp cont. Is there an HO mobile decoder with the same size physically as DH series, but has higher current ratings? Suggestions? While it is possible that the motor may be drawing too much current, it also may be possible that the motor brushes are not isolated from the frame of the locomotive. It also would be helpful for you to determine the stall current of the locomotive to see if the ...

Q:  As an HOn3 advocate and new to DCC with early PFM engines (2-6-0 & 2-8-0 motors in tender and some smaller ones) what would be the suggested decoder (am not sure am identifying the part correctly) that would be used in these engines? All I have seen so far identifies items used in H0 standard gauge. A:  Digitrax has many happy Narrow Gauge customers.  You'll need to consider three things to join their ranks.1.  The physical size of the decoder, because narrow gauge engines are smaller than Standard Gauge locomotives. Since your space is limited, using smaller decoders is the solution. Digitrax ...