Lifelike N-Scale Locomotives

The Life-Like RS2 locomotive frame is approx 1mm wider than than the Kato design for the RS2. Accordingly, special care must be taken to assure the loco frame does not come in contact with the DN163K2 decoder contacts. Please refer to the pictures below for details on the modification: Cut a piece of Kapton tape approx. 1/4" square and position it on an Xacto® type knife, small screwdriver blade or other similar tool.  Place the tape underneath the loco frame as shown above. A top view of the correctly placed tape. A side view of the correctly placed tape. Remember ...

The Life-Like GP18 locomotive can be modified to accept the DN163K2 board replacement decoder. The locomotive samples used by Digitrax for this instatllation needed to have the frame engagement clearance slots under the cab on the fireman-side widened about 1mm towards the rear of the locomotive (long hood end). This can be done with a small file or Dremel type tool, to allow the decoder to properly engage the casting with the power tab on this side. The engineer-side slots are OK to fit the decoder power pickup tab on this side. Be sure to check the motor tabs are safely ...

Prior to Disassembly Test the Decoder All Digitrax decoders are tested for proper operation before they leave the factory, but sometimes strange things happen. Therefore to insure your decoder is covered under our warranty policy, please give it a thorough test BEFORE you cut the wires. Test Run the Locomotive Be sure it runs correctly in both directions with no unusual noises or binding in the motor-gear train. If it checks out OK, then: Get Ready Before you start, get your tools and supplies together for this project. You will need the following items: DECODER TESTER - Such as the ...