If you are NOT plugged into a LocoNet port1. Use the 4 rotary address selector knobs on your UT4 to dial up the 2 or 4 digit address of the locomotive you want to run. To enter a 2-digit addresses, set the first two selector knobs to 0 and enter the two digit address on the 2 address selector knobs on the right hand side of the throttle (for example 0025).2. Plug the UT4 into any LocoNet port and automatic selection occurs.3. A Green Status light confirms that selection has been done successfully - You’re off and running!4. A Red Status light means the loco is ...
Stealing, or "sharing" is defined as acquiring control of a loco address that is being used by someone else on another throttle. To ‘Steal’ a loco:1. Unplug the UT4 from the LocoNet port.2. Dial up the address of the loco you want to steal.3. Press and hold the ‘STEAL’ key while plugging the throttle into the LocoNet jack. Note: To steal or dispatch another loco, you must unplug the UT4 and repeat the above sequence.