UP5 Univesal LocoNet Interconnect Panel

The jacks on the front and sides of the UP5, UR92, UR91, UR90, and LNRP front panels are Throttle Jacks and should only be used for connecting throttles to LocoNet.  They should not be used to connect to other LocoNet devices.  The jacks on the back of these units are LocoNet Jacks that are used for connecting LocoNet devices to the network.  Technically speaking! These units were designed to have the FRONT jack's second Railsync differential signal run as a diode-or'ed power source (for throttles).  This means that some cable orientations and power loads could cause unexpected operations in downstream LocoNet devices ...

  Q:  Can I mix UP-5s with Radio and IR panels? I want to upgrade slowly and still use the 400 throttles and the UT throttles while I mail them in to you one at a time for conversion to radio. A:  Yes, and you can continue to use the UP5's after conversion to radio; for instance, if you have visitors who bring their own Digitrax non-radio throttles. That's the real genius of LocoNet, since you can add to your railroad in any way. Note that you will need to plug in your throttle to LocoNet initially to select the locomotive before you ...

The Universal Panels all have a front made of sheet aluminum with a thin graphic overlay. There are four screw holes which are used to mount the panel on the layout fascia. When installing the panels, carefully tighten the screws; if they are too tight, the screw head will grab the graphic overlay and distort it.

1. The UP5 Universal Panel is designed for mounting on the fascia board of the layout. Cut a hole approximately 2.5” W x 1.5” H in the fascia board. Insert the UP5 through the hole with the face plate on the front of the fascia board. Attach the UP5 face plate to the fascia board with four #6 screws. Note: The UP5 uses the black screws to mount the front fascia plate.2. Connect the UP5 to LocoNet using pre-tested LocoNet cables. There are 2 LocoNet Jacks located at the back of the UP5 board for connecting LocoNet devices on your layout. ...

Hooking up the UP5's Power Supply (Optional but highly recommended to make sure LocoNet voltage is adequate to control large layouts)The optional power supply (PS14) can be connected to one or more UP and/or UR panels to provide additional power for LocoNet operation and for battery saving power to any Digitrax throttle that is plugged into any of the powered panels.1. Plug the PS14 into the DC jack located on the side of the UP5 circuit board.2. Connect the +Common point on each additional board (located between the two LocoNet jacks) to the powered board with 22AWG wire (Figure 2). ...

While it is possible to use RJ12 telco jacks as throttle jacks on LocoNet, the UP5 is much simpler to use and looks much more professional on the front of the layout. The UP5 is shipped as a kit that must be assembled.  You will need to attach the front panel to the circuit board using the screws provided as shown below before installing the entire unit on your layout.  If your front panel does not fit at a "perfect" 90 degree angle to the circuit board, this is will not affect the functionality of the unit.Make sure to line up the Track ...