ENGINE SELECTION
Place locomotive on the tracks controlled by the command station.
1. Turn the throttle knob you want to run a loco on about a quarter turn (this lets the controller know you want to address that side.)
2. Push the "Sel" Button
3. Turn the throttle knob you have selected until the left numbers of the display match the locomotive number you wish to run. (No decoder = 00)
4. Push "Sel" again.
5. Repeat for the other throttle.
If the number "33" appears it means that locomotive is unavailable (usually under the control of another throttle)
These simplified DT100 operating instructions courtesy of Alan Mitchell